Sizing Chart60+ TPP and class leading Conductive Heat transfer protection.
100% Kevlar knit fleece FR water repellent with 1 Pc. back shell.
A layered non-restrictive knuckle patch.
Extra layer of 6 oz. modacrylic liner sewn to the back shell.
A double backed 3 mil breathable Pyrotect Barricade moisture barrier.
100% water proof, viral/chemical penetration and blood borne pathogen protection.
A layered 6 oz. 65% Kevlar/35% Nomex stitch bond FR liner.
Five separate curved form fitting forchettes from 3.5 oz. to 4.0 oz. grain cow leather for maximum finger dexterity with a 60+ PPT rating.
Exclusive breathable adhesive for ensuring full liner/barrier glove bonding.
One piece palm 3.50 oz. to 4.0 oz. Eversoft® cow leather tanned with additives to stay soft when wet and low water absorbance with repeated soakings with a 60+ TPP rating.
This glove is proudly made in the USA with highly skilled employees.
This glove is certified to NFPA 1971-2007 by the Safety Equipment Institute (SEI).
FULL DESCRIPTION:
A true three dimensional form fitting glove curved finger design, inset thumb with enhanced finger dexeterity.
The one piece back shell is made from 100% Kevlar® knit fleece 7.5 oz. FR and water repellent fabric with exceptional flexibility across back of hand. A non-restricting Eversoft® knuckle band sewn across back for added knuckle protection. Elastic sewn into wrist crease for close fitting cuff.
Back is lined with a layer of 6 oz. modacrylic non-melting and non-driping liner.
A double backed 3 mil breatheable Pryotect Barricade moisture barrier 100 % water proof, viral/chemical penetration resistant, and provides blood borne pathogen protection. Barrier extends full length of glove for complete protection.
The 6 oz . 65% Kevlar® and 35% Nomex® stitch bond FR liner lines the inside back of hand.
Five separate finger fochettes curved and form fitted cut from 3.5 oz. to 4 oz. black flexor cowhide tanned to meet NFPA flame test for the highest finger dexterity.
Special breathable adhesive is coated over entire finger, thumb and palm area, ensuring full liner/barrier/glove adhesion meets NFPA requirements for liner retention.
Palm is 1 pc. 3.50 to 4.0 oz. Eversoft® cow leather tanned to meet NFPA flame resistance test and tanned with additives to stay soft when wet and low water absorbance with repeated soakings. Thumb is 2 pc. inset into palm to provide unrestricted movements of the thumb right to left.
Glove liner has a 2 inch grain leather cuff sewn inside glove wrist over top of the liner for the gauntlet model and bond with 1 1/2 inch black FR binding to finish cuff.
This glove is sewn completely with 30/3 Kevlar® thread.